An alcove installation means that the tub is installed against normally 3 walls. Your walls should be framed so that the tub fits right up to the studs. If you have too much gap it will be more difficult to get everything water tight. Ideally the tub sides should just touch the wood.
Tub Faucet Buying Guide
Choosing The Right Bathtub
On the other hand, there are some practical advantages to built-in bathtubs, especially in the smaller spaces so many of us are now living in. They just fit better in most bathrooms and they are often easier to use and clean. But each is not for everyone, and not for every bathroom. Our guide will give you everything you need to know to make the right decision. Ah, the delicious freestanding tub. They attract attention, instantly grabbing your eye when you enter the bathroom.
Bathtub Installation Guide
When it comes to bathroom remodeling, few decisions are more controversial than whether to keep the tub. For some hard facts on who is actually doing what about the tub versus shower conundrum, the U. Houzz Bathroom Trends Study asked more than 1, U.
However, if you have some plumbing and construction experience, this may be a DIY project that you feel comfortable tackling. If you're looking for a starting point, this guide provides an outline of the job. To install a bathtub, start by installing a 2- by 4-inch ledger board to the length of the wall that the long edge of the tub will be against. Then, attach the drain to the new tub, and connect the overflow drain. Next, set the tub in place, and secure it to the studs using the vertical lip around the outside of it.